Products

PRODUCTS

> MeshAP 5100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 3100G Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point with built-in GPS Antenna

>MeshAP 3100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 2180 Outdoor - High Performance 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 2100 Outdoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 1100 Indoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP Manager Web (HTML) based GUI Management Tool for MeshAP Access Points

SUPPORT

Where To Buy

> Online Store

Technical Support
> support@arrowspan.com

Information
> info@arrowspan.com

Webmaster
> webmaster@arrowspan.com

Feedback
> feedback@arrowspan.com

Home > Support > Installation & Configuration

SAFETY GUIDE & INSTALLATION TIPS

Safety Guide for ArrowSpan's Indoor MeshAP 1100

Make sure to read the installation instructions thoroughly before you install your unit(s).
To avoid the risk of being electrocuted, do not work on the unit(s) during a lightning storm.
Do not touch the antenna while the unit is transmitting or receiving.
Do not hold the antenna very close to any exposed body parts while it is transmitting.
Antennas should be placed at least 20cm from the bodies of all persons.
If you are mounting the unit on the wall, make sure it can hold the MeshAP’s weight of about 1lb., plus the additional weight of any attached cables.
Place access points in a location where it is hard for people to turn them off.

Installation Tips for ArrowSpan's Indoor MeshAP 1100

Make sure there is a power outlet at each access point location.
Configure the mesh manager first, and then the rest of the nodes.
In order to insure the best signal possible, make sure the nodes are not being blocked by a microwave or any metal or concrete objects.

Safety Guide for ArrowSpan's Outdoor MeshAP units

Make sure to read the installation instructions thoroughly before you install your unit(s).
To avoid the risk of being electrocuted, do not work on the unit(s) during a lightning storm.
Do not install any unit(s) near heat sources such as radiators or any other equipment that produce heat.
Do not place antennas near power circuits or power lines. Choose your location carefully and keep in mind that power lines look similar to phone lines so always use caution.

Installation Tips for ArrowSpan's Outdoor MeshAP units

Before you install your outdoor unit(s), choose a location where buildings and trees will not block the signal.
Make sure to install your outdoor unit at a moderate height (approximately 40 feet), so it can provide a clear signal to neighboring nodes.
When installing the unit(s), allow at least 10 feet of seperation between each unit.
Do not mount units on metal objects, doing so will drastically reduce the signal strength.

> Back to Installation & Configuration