PRODUCTS
> MeshAP 5100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point
> MeshAP 3100G Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point with built-in GPS Antenna
>MeshAP 3100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point
> MeshAP 2180 Outdoor - High Performance 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point
> MeshAP 2100 Outdoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point
> MeshAP 1100 Indoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point
> MeshAP Manager Web (HTML) based GUI Management Tool for MeshAP Access Points
SUPPORT
> Downloads
> Warranty
> FAQ
> Product Registration
> Update Request
Where To Buy
Technical Support
> support@arrowspan.com
Information
> info@arrowspan.com
Webmaster
> webmaster@arrowspan.com
Feedback
> feedback@arrowspan.com
Home > Products
Firmware Update
Direct Unit Update – Mesh Station
Step 1. Login to the MeshAP Access Point.
Step 2. Go to the Status link under the AP section, and check the current firmware version/build date.
Step 3. Go to Administration: Firmware Update link
Click on “Browse…” to select a firmware image for upgrade.
Step 4. Click Upgrade to start firmware upgrade process. The firmware upgrade process takes about 2 minutes.
Step 5. When the firmware upgrade is ready, the following page will be displayed on the screen. Click “Continue”.
If after 30 seconds this screen still appears on the screen, please click on the Continue button and re-login to the unit.
> Back to Installation & Configuration
Copyright ©2006 ArrowSpan, Inc. All rights reserved. Privacy Policy